Table of Contents
Advertisement
Innovative Hearth Products
DRT40 Multi-View Series Direct-Vent Gas Fireplace
MINIMUM CLEARANCES
Back and Sides
Top Spacers
Floor
From Bottom of Unit To Ceiling
Vent
SERVICE CLEARANCES
Front, Back, Sides
Table 5
A Combustible Wall
may extend to any
length on one side
only. If installed as
shown, opposite side
is limited to 6".
Figure 8
Front face assembly
Control Compartment (behind assembly)
Control Compartment Access Panel
Figure 9 - Unit Parts Identification
*
Inches (millimeters)
1/2 (13)
0 (0) from Spacers Or Dimples **
0 (0)
0 (0)
64 (1626)
3 (77)
* / 1 (26)
Top
Sides & Bottom
Feet (meters)
3 feet (0.9 meters)
Top View of
Fireplace
6"
Combustible Walls
Hood
Barrier
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Installation and Operation Instructions
900299-00, 02/2019
WARNING
Failure to position the parts in
accordance with these diagrams
or failure to use only parts
specifically approved with this
appliance may result in property
damage or personal injury.
AVERTISSEMENT
Risque de dommages ou de
blessures si les pièces ne sont
pas installées conformément à
ces schémas et ou si des pièces
autres que celles spécifiquement
approuvées avec cet appareil
sont utilisées.
DETAILED INSTALLATION STEPS
The appliance is shipped with all gas controls
and components installed and pre-wired.
1. Remove the shipping carton.
2. Remove Front Face Assembly (refer to
Figure 10, page 12) by lifting and pulling
straight out from the fireplace.
3. Lift the pressure relief plates and remove
the cardboard from underneath each of
them.
4. Open the two latches (located under the
firebox floor) securing the glass enclosure
panel. Remove the panel by tilting it outward
at the bottom and lifting it up. Set the door
aside protecting it from inadvertent damage.
See Figure 60 on Page 36.
11
Advertisement
Table of Contents
