Innovative Hearth Products
DRT40 Multi-View Series Direct-Vent Gas Fireplace
TABLE OF CONTENTS
Packaging ...................................................Page 4
Introduction ................................................Page 4
Requirements for the
Location ....................................................Page 7
Maintenance ................................................Page 47
Warranty ....................................................Page 63
Please read and understand these
instructions before beginning your
installation.
4
PACKAGING
The assembled vented gas fireplace heater is
packaged with:
1 - one log set located within the firebox.
2 - one plastic bag containing the literature
package, which consists of the Installation
and Operation manual, Hot Glass Safety
Flyer, and Safety-In-Operation Warning La-
bels, 8 (DRT40ST), 4 (DRT40PF, DRT40CR,
DRT40CL) nailing flanges.
3 - two hoods (DRT40ST), or three hoods
(DRT40PF) taped to the top of the fireplace.
4 - one plastic bag of glowing embers, one
plastic bag of decorative volcanic stone
and one bag of vermiculite is located in the
bottom compartment.
5 - one vent restrictor to be applied as shown on
Page 14; restrictor is taped to the envelope.
6 - barriers
7 - front face assemblies
NOTE:
• If the barrier becomes dam-
aged, the barrier shall be re-
placed with the manufacturer's
barrier for this appliance.
• For use with barrier(s) Part
No(s). J7420 (ST Models),
J7420 and J7421 (PF, CL, and
CR Models).
INTRODUCTION
The Electronic appliances are designed to op-
erate on natural or propane gas. An electronic
intermittent pilot ignition system provides safe,
efficient operation. External electrical power is
required to operate these units.
These vented gas fireplace heaters are sealed
combustion, air-circulating gas fireplaces de-
signed for residential applications.
Approved Vent Components - These fireplaces
are designed, tested and listed for operation
and installation with the following vent com-
ponents only:
•
Secure Vent
Direct-Vent System Compo-
®
nents manufactured by IHP,
•
Secure Flex
Flexible Vent Components
®
manufactured by IHP and
•
Z-FLEX
Model GA Venting Systems listed
®
to UL1777 and ULCS635 manufactured by
Flexmaster Canada Limited.
Use only the correct size venting (4-1/2" inner
and 7-1/2" outer).
These approved vent system components are
labeled for identification. DO NOT use any
other manufacturer's vent components with
these appliances.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Installation and Operation Instructions
900299-00, 02/2019
GENERAL INFORMATION
WARNING
Young children should be care-
fully supervised when they are
in the same room as the appli-
ance. Toddlers, young children
and others may be susceptible
to accidental contact burns. A
physical barrier is recommended
if there are at-risk individuals in
the house. To restrict access to
a fireplace or stove, install an
adjustable safety gate to keep
toddlers, young children and
other at-risk individuals out of
the room and away from hot
surfaces.
AVERTISSEMENT
Les jeunes enfants devraient être
surveillés étroitement lorsqu'ils
se trouvent dans la même pièce
que l'appareil. Les tout petits,
les jeunes enfants ou les adultes
peuvent subir des brûlures s'ils
viennent en contact avec la sur-
face chaude. Il est recommandé
d'installer une barrière physique
si des personnes à risques habi-
tent la maison. Pour empêcher
l'accès à un foyer ou à un poêle,
installez une barrière de sécu-
rité; cette mesure empêchera les
tout petits, les jeunes enfants et
toute autre personne à risque
d'avoir accès à la pièce et aux
surfaces chaudes.
Children and adults should be alerted to the
hazards of high surface temperature and
should stay away to avoid burns or clothing
ignition.
Les enfants et les adultes devraient être infor-
més des dangers que posent les températures
de surface élevées et se tenir à distance afin
d'éviter des brûlures ou que leurs vêtements
ne s'enflamment.
DO NOT ATTEMPT TO ALTER OR MODIFY
THE CONSTRUCTION OF THE APPLIANCE OR
ITS COMPONENTS. ANY MODIFICATION OR
ALTERATION MAY VOID THE WARRANTY,
CERTIFICATION AND LISTINGS OF THIS UNIT.