Pre-Installation Steps; Typical Installation Sequence; Detailed Installation Steps; Step 1. Framing - Superior Fireplaces Signature DRT6340TYN Installation Instructions Manual

INNOVATIVE HEARTH PRODUCTS • POWER VENT DV GAS FIREPLACES (DRT63__TYN / DRC63__TYN) • INSTALLATION INSTRUCTIONS

PRE-INSTALLATION STEPS

The appliance is shipped with all gas controls
and components installed and pre-wired.
Before installing the appliance, follow these steps:
1. Remove the shipping carton.
2. Remove the shipping pad, exposing the front
glass door.
3. Using a Phillips screwdriver, unfasten the two
(2) screws located at the top of the glass frame
(see Figure 40 on Page 24). Tilt the top of the
glass frame away from the unit. Lift it carefully
offthebottomdoortrackandsetthedooraside,
protecting it from inadvertent damage.
4. Remove the embers and volcanic stone from
the control compartment.

TYPICAL INSTALLATION SEQUENCE

The typical sequence of installation is outlined
below. However, each installation is unique and
may result in variations to the steps described.
See the page numbers references in the follow-
ing steps for detailed procedures.
Step 1. (Page 9) Construct the appliance
framing. Position the appliance within
the framing and secure with nailing
brackets.
Step 2. (Page 11) Route gas supply line to the
right side.
Step 3. (Page 12) Install the vent system and
exterior termination.
Step 4. (Page 18) Field Wiring
Connect 120 VAC electrical power to
the appliance receptacle.
Step 5. (Page 20) Remove glass door assem-
bly.
Step 6. (Page 21) Make connection to gas
supply.
Step 7. (Page 21) Install firebox liner kit.
Step 8. (Page 21) Verify appliance operation.
Step 9. (Page 22) Install volcanic stone, glow-
ing embers, and logs.
Step 10. (Page 24) Install glass door assembly.
Step 11. (Page 24) Adjust burner to ensure
proper flame appearance.
Step 12. (Page 27) Attach Safety-in-Operation
Warnings.

DETAILED INSTALLATION STEPS

Step 1. FRAMING

Frame these appliances as illustrated in Figure
8 on Page 10, unless the appliance is to be
installed in a corner. See Figure 9 on Page 11
for corner framing installations. All framing
details must allow for a minimum clearance
to combustible framing members as shown in
Table 5 on Page 8.
If the appliance is to be elevated above floor
level, a solid continuous platform must be
constructed below the appliance.
Headers may be in direct contact with the ap-
pliance top spacers but must not be supported
by them or notched to fit around them.
The fireplace should be secured to the side fram-
ing members using the unit nailing flanges - one
top and bottom on each side of the fireplace front
(see Figure 7). Use 8d nails or their equivalent.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
NOTE: The nailing flanges, combustible members
and screw heads located in areas directly adja-
Unit Being Secured By Its Nailing Flanges
To The Framing
cent to the nailing flanges, are EXEMPT from the
1/2" clearance to combustible requirements for
the firebox outer wrapper. Combustible framing
may be in direct contact with the nailing flanges
and may be located closer than 1/2" from screw
heads and the firebox wrapper in areas adjacent
to the nailing flanges. Frame the opening to
the exact dimensions specified in the framing
details of this manual.
Unit Being Secured by Its Nailing
Left Side Front Corner of Fireplace Shown
(Right Side Requirements the Same).
Flanges to the Framing
Figure 7 - Unit Secured by Nailing
Flanges to the Framing
9