Chapter 2 Part Names - Mitsubishi Electric NZ2MF2S1-32D User Manual

2
PART NAMES
This chapter describes part names of the I/O module.
• Screw terminal block type
(1)
(7) (8)
• Spring clamp terminal block type
(1)
(7) (8)
No. Name
(1) Ethernet port
100M LED
SD/RD LED
(2) PW LED
RUN LED
D LINK LED
ERR. LED
(3) Function setting switch
(4) IP address setting switch
2 PART NAMES
14
(2) (3) (4)
(9)
(2) (3) (4)
(9)
Application
Port connector for network connection. Connect an Ethernet cable.
For wiring method and precautions, refer to the following.
Page 79 Wiring of Ethernet cable
Indicates the link status.
On: Linkup in progress
Off: Linkdown in progress
Indicates the status of data communication.
On: Data being sent or received
Off: Data not sent/received
Indicates the power supply status of the I/O module.
On: Power supply ON
Off: Power supply OFF
Indicates the operating status of the I/O module.
On: Operating normally.
Off: A major error has occurred.
Indicates the data link status of the I/O module.
On: Data link in operation. (cyclic transmission in progress)
Flashing: Data link stop (cyclic transmission stopped)
Off: Data link not performed. (disconnected)
Indicates the error status of the I/O module.
On: A moderate error or major error has occurred.
Flashing: A minor error has occurred.
Off: Operating normally.
Used for the input response time setting function and output HOLD/CLEAR setting function.
For function details and setting method, refer to the following.
Page 86 Input Response Time Setting Function
Page 87 Output HOLD/CLEAR Setting Function
Switch for setting the fourth octet of IP address
Page 69 IP address setting switch setting
(5) (6)
(5) (6)