Chapter 2 Part Names - Mitsubishi Electric NZ2GF2B-60TCTT4 User Manual

CHAPTER 2
This chapter describes the part names of a temperature control module.
Number Name
1) Station number setting switch
PW LED (green)
RUN LED (green)
MODE LED (green)
2)
D LINK LED (green)
ERR. LED (red)
ALM LED (red)
PART NAMES
2)
3)
1) 4)
A rotary switch for the following setting and test.
• Station Number Setting ( Page 85, Section 6.1)
• Unit Test ( Page 282, Section 11.5)
When operating the station number setting switch, use a flathead screwdriver with a tip width of 3.5mm or
less.
Indicates the power supply status of the temperature control module.
• On: Power-on
• Off: Power-off
Indicates the operating status of the temperature control module.
• On: Operating normally
• Off: Major error occurred
Indicates the mode of the temperature control module.
• On: In online mode
• Flashing: In unit test mode
• Off: At completion of unit test
Indicates the data link status of the temperature control module.
• On: Data link established (cyclic transmission in progress)
• Flashing: Data link established (cyclic transmission stopped)
• Off: Data link not established (disconnected)
Indicates the error status of the temperature control module.
• On: Moderate error or major error occurred
• Flashing: Warning issued
• Off: Operating normally
Indicates the alarm status of the temperature control module.
• On: Alert 1 to 4 issued, Process alarm upper lower limit alert issued, or Rate alarm upper lower limit alert
issued
• Flashing: Out of range of PV range measured temperature value upper lower limit or in loop disconnection
detection
• Off: No alarm of the module
6)
5) 7)
Description

CHAPTER 2 PART NAMES

31
2