Table of Contents
Advertisement
Wiring of spring clamp terminal block
■Wire to be used
The following table describes the wire to be connected to the spring clamp terminal block.
Diameter
22 to 16 AWG
■Applicable solderless terminal
The following table lists the applicable solderless terminal.
Product name
Model name
Bar solderless
AI 0.5-10WH
terminal
AI 0.75-10GY
A 0.5-10
A 0.75-10
A1.0-10
A1.5-10
*1 When using a solderless terminal with an insulation sleeve, select the terminal whose applicable wire size is 0.75 or smaller.
*2 Use a bar solderless terminal tool whose manufacturer is the same as that of the bar solderless terminal used.
■Installing or removing the terminal block
The following procedures show how to install and remove the terminal block.
• Lock and release lever positions
To make it easy to install and remove the terminal block, a three-stage positioning stopper is attached so that the lever does
not freely turn around.
When installing or removing the terminal block, move the lever to the lock or release lever position.
Figure viewed from the module right surface: When pulling the terminal block
(2)
(1)
Figure viewed from the module right surface: When insertion of the terminal
block has completed
(1)
(2)
• Removal procedure
Turn the lever to the release lever position and remove the terminal block from the module.
• Installation procedure
Move the lever to the locking lever position and push the terminal block. If the terminal block is fully pushed in, the hook of the
lever hangs on the module and fits the terminal block.
Type
Stranded
Applicable wire size
0.5
0.75
0.5
0.75
1.0
1.5
Material
Copper
*1
Bar solderless terminal
*2
tool
CRIMPFOX6
1.
Release lever position
This lever position shows the state in which the terminal
block (1) has been completely pulled out from the module.
Turn from the locking lever position to the release lever
position (2) and lift the terminal block from the module.
2.
Lock lever position
This position shows the state in which the terminal block (1)
completely fits the module. Check the lock lever position (2)
and pull the terminal block lightly to confirm that the module
completely fits the terminal block.
6 INSTALLATION AND WIRING
Temperature rating
75 or more
Contact
PHOENIX CONTACT GmbH & Co. KG
6.5 Wiring
6
81
Advertisement
Table of Contents
Troubleshooting
