Advertisement
Finding a Station
AM-FM: Press
this button to switch between
AM, FMl
and FM2. The display shows your selection.
TUNE: Press this knob lightly so it extends, Turn it to
choos'e radio stations. Push the knob back into its stored
position when you're not using it,
SEEK: Press the up or down arrow to go to the next
higher or lower station and stay there.
PUSHBUTTONS:
The
six
numbered pushbuttons let
you return to your favorite stations.
You can
set up to
18
stations (six
AM, six FM 1 and
six
FM2).
Just:
1. Press AM-FM to select the band.
2. Tune in the desired station.
3. Press and hold one of the six numbered buttons until
SET appears on the display. Whenever you press that
numbered button, the station you set will return.
4. Repeat the steps for each pushbutton,
Setting the Tone
EQUALIZER: A seven band equalizer is part of your
audio system. Slide the levers up to boost or down to
reducle frequency range.
Adjusting the Speakers
BAL: Press this knob lightly so it extends. Turn it to
move the sound to the left or right speakers. The middle
position balances the sound between the speakers.
FADE: Press
this knob lightly
so
it extends.
T u r n
it to
move the sound to the front or
rear
speakers. The middle
position balances the sound between the speakers.
Push these knobs back into their stored positions when
you're not using them.
Playing a Cassette Tape
Your tape player is built to work best with tapes that are
30 to 45 minutes long
on each side. Tapes longer than
that are so thin they
may
not work well in this player.
While the tape is playing, use the VOL, FADE and
BAL
controls just as you do for the radio. The display will
show an arrow to show which side of the tape is playing.
When the down indicator arrow is lit, selections listed
on the bottom side of the cassette are playing. When the
up arrow is lit, selections listed on the top side of the
cassette are playing. The tape player automatically
begins playing the other side when it reaches the
end of
the tape.
3-16
Advertisement
