Using The Call Command; Using The Re-Dial Command - Chevrolet 2010 Impala Owner's Manual

4. Continue entering digits until the number to be
dialed is complete. After the whole number has
been entered, say "Dial". The system responds
with "OK, Dialing" and dials the number.
•
If an unwanted number is recognized by the
system, say "Clear" at any time to clear the
last number.
•
To hear all of the numbers recognized by the
system, say "Verify" at any time and the
system will repeat them.

Using the Call Command

b g
1. Press and hold
responds with "Ready" followed by a tone.
2. Say "Call". The system responds with "Call using
<phone name>. Please say the name tag" followed
by a tone.
4-80
for two seconds. The system
3. Say the name tag of the person to call.
•
If the system clearly recognizes the name tag it
responds with "OK, calling, <name tag>" and
dials the number.
•
If the system is unsure it recognizes the right
name tag, it confirms the name tag followed
by a tone. If the name tag is correct, say "Yes".
The system responds with "OK, calling,
<name tag>" and dials the number. If the name
tag is not correct, say "No". The system will
ask for the name tag to be re-entered.
Once connected, the person called will be heard
through the audio speakers.

Using the Re-dial Command

b g
1. Press and hold
responds with "Ready" followed by a tone.
2. After the tone, say "Re-dial". The system responds
with "Re-dial using <phone name>" and dials the
last number called from the connected Bluetooth
phone.
Once connected, the person called will be heard
through the audio speakers.
for two seconds. The system