Using The Call Command - Chevrolet 2010 Corvette Owner's Manual

Using the Digit Dial Command
b g
1. Press and hold
responds with "Ready" followed by a tone.
2. Say "Digit Dial". The system responds with "Digit
dial using <phone name>, please say the first digit
to dial" followed by a tone.
3. Say the digit to be dialed one at a time. Following
each digit, the system will repeat back the digit it
heard followed by a tone.
4. Continue entering digits until the number to be
dialed is complete. After the whole number has
been entered, say "Dial". The system responds with
"OK, Dialing" and dials the number.
•
If an unwanted number is recognized by the
system, say "Clear" at any time to clear the
last number.
•
To hear all of the numbers recognized by the
system, say "Verify" at any time and the
system will repeat them.
for two seconds. The system

Using the Call Command

b g
1. Press and hold
responds with "Ready" followed by a tone.
2. Say "Call". The system responds with "Call using
<phone name>. Please say the name tag" followed
by a tone.
3. Say the name tag of the person to call.
•
If the system clearly recognizes the name tag it
responds with "OK, calling, <name tag>" and
dials the number.
•
If the system is unsure it recognizes the right
name tag, it confirms the name tag followed
by a tone. If the name tag is correct, say
"Yes". The system responds with "OK, calling,
<name tag>" and dials the number. If the
name tag is not correct, say "No". The system
will ask for the name tag to be re-entered.
Once connected, the person called will be heard
through the audio speakers.
for two seconds. The system
4-99