Headlamp High/Low-Beam Changer; Flash-To-Pass; Windshield Wipers - Chevrolet 2010 Impala Owner's Manual

Turn Signal On Chime
If either one of the turn signals are left on and the
vehicle has been driven more than 3/4 mile (1.2 km),
a chime will sound.

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to high
beam, push the turn signal/multifunction lever away
from you.
This instrument panel cluster light
high beam lamps are turned on while the ignition is
in ON/RUN.
To change the headlamps from high beam to low beam,
pull the turn signal lever toward you.

Flash-to-Pass

This feature is used to signal to the vehicle ahead that
you want to pass.
If the headlamps are off or in the low-beam position,
pull the turn signal lever toward you to momentarily
switch to high-beams.
Release the lever to turn the high-beam headlamps off.
3 comes on if the

Windshield Wipers

Turn the band with the wiper symbol to control the
windshield wipers.
8 (Mist): Single wipe, turn to
Several wipes, hold the band on
9
(Off): Turns the windshield wipers off.
6
(Adjustable Interval Wipes): Turn the band up for
more frequent wipes or down for less frequent wipes.
6 (Low Speed): Slow wipes.
?
(High Speed): Fast wipes.
Clear ice and snow from the wiper blades before using
them. If frozen to the windshield, carefully loosen or
thaw them. Damaged wiper blades should be replaced.
See Windshield Wiper Blade Replacement on
page 6-49.
Heavy snow or ice can overload the wiper motor.
A circuit breaker will stop the motor until it cools down.
8 , then release.
8 longer.
4-5