Setting Cruise Control - Chevrolet 2010 Impala Owner's Manual

T
(On/Off): Press to turn cruise control on and off.
The indicator is lit when cruise control is on.
+ RES (Resume/Accelerate): Press to make the
vehicle accelerate or resume to a previously set speed.
SET– : Press to set the speed or make the vehicle
decelerate.
[
(Cancel): Press to cancel cruise control.
The cruise control buttons
are located on left side of
the steering wheel.

Setting Cruise Control

Cruise control will not work if the parking brake is set,
or if the master cylinder brake fluid level is low.
The cruise control light on the instrument panel cluster
comes on after the cruise control has been set to
the desired speed. See Instrument Panel Cluster
on page 4-22.
WARNING:
{
If you leave your cruise control on when you are not
using cruise, you might hit a button and go into
cruise when you do not want to. You could be
startled and even lose control. Keep the cruise
control switch off until you want to use cruise
control.
T
1. Press the button.
2. Get up to the desired speed.
3. Press and release the SET– button located on the
steering wheel.
4. Take your foot off the accelerator.
4-7