Install LED Board
1. Install eight screws securing LED board to front cover using a Phillips screwdriver.
NOTE: Tighten screws in the following order.
2. Install left and right ribbon cables by aligning carefully and inserting into board cable connectors.
3. Press ground wire onto ground terminal by hand.
Install Rear Cover
1. Install headphone jack cable and USB cable into rear cover.
Non-Treadmill console shown
Item
1
2
3
Item
1
2
3
4
5
Page 46 of 153
Description
Left ribbon cable
Ground terminal
Right ribbon cable
Description
Front cover
Main board
Headphone jack cable
USB connector cable
Rear cover
Qty
1
1
1
Qty
1
1
1
1
1