Error 151
Error Message Displayed to user
E151
Condition
Console GO / STOP / PAUSE key not detected
Cause
Console GO / STOP / PAUSE keypad disconnected.
Remedy
• Insure all connectors are connected properly (Specifically P13 and P14). P13 is connector for console-front GO /
STOP / PAUSE keys. Unseat / reseat connectors
• On PowerMill remote bullhorn bars have STOP key which is plugged into P14 and P22. Those must be plugged in
as well for that unit type.
• If error continues, replace console.
Page 136 of 153