Table of Contents
Advertisement
500
5-6. Other interior features
Test the HomeLink
3
by pressing the newly pro-
grammed button.
If a HomeLink
grammed for a garage door, check to
see if the garage door opens and
closes. If the garage door does not
operate, see if your remote control
transmitter is of the rolling code type.
Press and hold the programmed
HomeLink
button. The remote con-
trol transmitter is of the rolling code
type if the HomeLink
flashes rapidly for 2 seconds and then
remains lit. If your transmitter is of the
rolling code type, proceed to the
heading "Programming a rolling code
system".
Repeat the steps above to program another device for each of the
4
remaining HomeLink
Programming a Rolling Code system
■
If your device is Rolling Code equipped, follow the steps under the
heading "Programming the HomeLink
steps listed below.
Locate the learn button on the ceiling mounted garage door opener
1
motor. The exact location and color of the button may vary by brand
of garage door opener motor.
Refer to the operation manual supplied with the garage door opener for the
location of the learn button.
Press the learn button.
2
Following this step, you have 30 seconds in which to initiate step 3 below.
operation
button has been pro-
indicator light
buttons.
" before proceeding with the
Advertisement
Table of Contents
