Table of Contents
Advertisement
The Adaptive High-beam System can be operated when
■
The engine switch is in IGNITION ON mode.
Camera sensor detection information
■
High beam may not be automatically turned off or changed to variable shade beam
●
in the following situations:
• When oncoming vehicles suddenly appear from a curve
• When the vehicle is cut in front of by another
• When oncoming or preceding vehicles are hidden from sight due to repeated
curves, road dividers or roadside trees
High beam may be turned off or variable shade beam may be changed to if an
●
oncoming vehicle that is using fog lights without using the headlights is detected.
House lights, street lights, red traffic signals, and illuminated billboards or signs may
●
cause the high beam to turn off or variable shade beam to be changed to and may
change the area that is shielded.
The following factors may affect the amount of time taken to turn high beam on or
●
off, or the speed by which the shielded areas change:
• The brightness of headlights, fog lights, and tail lights of oncoming and preced-
ing vehicles
• The movement and direction of oncoming and preceding vehicles
• When a oncoming or preceding vehicle only has operational lights on one side
• When a oncoming or preceding vehicle is a two-wheeled vehicle
• The condition of the road (gradient, curve, condition of the road surface etc.)
• The number of passengers and amount of luggage
High beam and variable shade beam may be turned on or off when unexpected by
●
the driver.
Small vehicles, such as bicycles, may not be detected.
●
4-3. Operating the lights and wipers
295
4
Advertisement
Table of Contents
