Lexus LS 460 2017 Manual page 161

Switching the door unlock function
■
It is possible to set which doors the entry function unlocks using the wireless remote
control.
Turn the engine switch off.
1
Cancel the intrusion sensor and tilt sensor of the alarm system to prevent unin-
2
tended triggering of the alarm during the setting change. (if equipped) (P. 115)
Press and hold
3
and holding
The setting changes each time an operation is performed, as shown below. (When
changing the setting continuously, release the buttons, wait for at least 5 seconds,
and repeat step .)
3
Multi-information
display
To prevent unintended triggering of the alarm, unlock the doors using the wireless
remote control and open and close a door once after the settings have been
changed. (If a door is not opened within 30 seconds after
doors will be locked again and the alarm will automatically be set.)
In case that the alarm is triggered, immediately stop the alarm. (P. 113)
3-2. Opening, closing and locking the doors
, or for approximately 5 seconds while pressing
.
Unlocking function
Hold a door handle to unlock
all doors
Hold the driver's door handle
to unlock only the driver's door Exterior: Beeps 3 times
Hold a passenger's door han-
dle to unlock all the doors
Hold the door handle to
unlock the front and rear doors
on your side
Hold the door handle to
unlock the door
Beep
Exterior: Beeps twice
Interior: Rings once
Interior: Rings once
Exterior: Beeps 4 times
Interior: Rings once
Exterior: Beeps once
Interior: Rings once
is pressed, the
161
3