Using the door lock switch
Carry only one of the keys (including the card key) to which you want to
link the driving position. If 2 or more keys are in the vehicle, the driving
position cannot be linked properly.
Turn the engine switch off and close the driver's door.
1
While pressing the recalled
2
switch, press and hold the door
lock switch (either lock or
unlock)
until
sounds.
Recall procedure
■
Carry the electronic key that has been registered to the driving posi-
1
tion, and then unlock and open the driver's door using the smart
entry & start system or wireless remote control.
The driving position will move to the recorded position (not including the
steering wheel). However, the seat will move to a position slightly behind the
recorded position in order to make entering the vehicle easier.
If the driving position is in a position that has already been recorded, the seat
and outside rear view mirrors will not move.
Turn the engine switch to ACCESSORY mode or fasten your seat-
2
belt.
The seat and steering wheel will move to the recorded position.
the
buzzer
3-3. Adjusting the seats
221
3