Table of Contents
Advertisement
220
3-3. Adjusting the seats
Operating the driving position memory after turning the engine switch off
■
Driver's seat:
Recorded driving positions (except the steering wheel position) can be recalled up
to 180 seconds after the driver's door is opened and up to 60 seconds after it is
closed again.
Front passenger's seat:
Recorded seat positions can be recalled up to 180 seconds after the front passen-
ger's door is opened.
In order to correctly use the driving position memory function
■
If a seat position is already in the furthest possible position and the seat is operated in
the same direction, the recorded position may be slightly different when it is recalled.
Memory recall function (driver's side only)
Each electronic key (including a card key) can be registered to recall your
preferred driving position.
Registering procedure
■
Record your driving position to switch "1", "2" or "3" before performing
the following:
Using the wireless remote control
Turn the engine switch off and close the driver's door.
1
While pressing the desired
2
switch ("1", "2" or "3"), press
on the wireless remote
control
sounds.
To prevent unintended triggering of the alarm, open and close a door
once after a driving position has been recorded. (If a door is not
opened within 30 seconds after
locked again and the alarm will automatically be set.)
In case that the alarm is triggered, immediately stop the alarm.
(P. 113)
until
the
buzzer
is pressed, the doors will be
Advertisement
Table of Contents
