Switching Output X: Upper Switching Limit (Switching Point); Switching Output X: Lower Switching Limit (Switch-Back Point) - Bosch Rexroth WGM Operating Instructions Manual

24/46 Operation
Bosch Rexroth AG, RE 51550-B/09.2019
Notice: The switching function can be designated in different ways:
Measurement
open
(0)
rising normally open contact
falling normally closed contact
NO (normally open)

5.1.7.2 Switching output x: Upper switching limit (switching point)

The upper switching limit for the switching output Out x is set in the following
submenu:
Switching point for OUT x
Setting range: [
Notice:
▶
▶
▶

5.1.7.3 Switching output x: Lower switching limit (switch-back point)

The lower switching limit for the switching output Out x is set in the following
submenu:
Switch-back point for OUT x
Setting range: [
Notice:
▶
▶
▶
closed
(1)
hNO
O.lO ]...[ O.hI ]
The switching point must be selected within the range limits
(see menu Basic settings advanced functions).
If the switching output OUT x has been assigned the window
function, is displayed. The set value corresponds to the
upper window limit.
If the switching output OUT x has been assigned the frequency
output function,
is displayed. The set value corresponds to
the frequency 100 Hz.
]...[ ]
O.lO O.hI
The switch-back point must be selected within the range limits.
If the switching output OUT x has been assigned the window
function, is displayed. The set value corresponds to the
lower window limit.
If the switching output OUT x has been assigned the frequency
output function,
is displayed. The set value corresponds to
the frequency 1 Hz.
open closed
(0) (1)
rising normally closed contact
falling normally open contact
NC (normally closed)
hNC