5.1.6.5 Defining the switching outputs
Here you can define the switching outputs.
Using the function "Define switching outputs", you can define the switching outputs
(
and
). It is possible to define the switching outputs as
.OUi
.OU2
R
R
.
TeMp
The following options are available:
Err
Notice:
▶
▶
5.1.6.6 Setting the update rate of the display
The update rate of the display can be set depending on the application.
The display can also be switched off completely. The function of the LED remains
unchanged.
The following options are available:
quick
Notice:
Error messages are displayed even if the display is switched off.
TEMP
The switching outputs 1 and 2 can alternatively be connected as
error indicators. In this case, the output is connected as a normally
closed contact which opens when the range is exceeded or another
error state. However, the LED assigned to the output is generally not
activated, as all 6 LEDs in the status bar flash when an error occurs.
If a switching output is defined as an error indicator, it is no longer
available in the normal switching output settings.
medium
Operation
,
e
hUMi
RR
HuMi
slow
display off
RE 51550-B/09.2019, Bosch Rexroth AG
21/46
or