Operation; Wgm-D/Wgm-R; Switch-On Procedure; Led Status Displays - Bosch Rexroth WGM Operating Instructions Manual

14/46

Operation

Bosch Rexroth AG, RE 51550-B/09.2019
5 Operation
The device may not be operated outside its specifications!

5.1 WGM-D/WGM-R

This explanation of operation refers to options equipped with a display unit.

5.1.1 Switch-on procedure

When the device is connected to the supply voltage, it switches on immediately.
At the beginning, the software version appears briefly and the device checks the
installed components simultaneously. The display then changes to the measured
value display.
The function of the display and control unit is described below:
dtet dte e e e t t t
Operating
buttons
Fig. 2: Switch-on procedure
If an error message appears in the display during operation, please refer to the table
Troubleshooting in chapter "Service and Repair".

5.1.2 LED status displays

LEDs above the measured value display indicate the status of the switching outputs.
The LEDs are permanently assigned to the switching outputs.
The following table shows the factory settings for the assignment of the switching
outputs to filling level and temperature:
Table 2: Description of LED status displays
Figure
The switching behavior of the LEDs (illuminated with closed or open switching
contact) can be changed.
NOTICE
Description
LED 1 - yellow
Status switching output 1
LED 2 - red
Status switching output 2
2 switching outputs
Humidity
Temperature