Technical Datas; Repair Information - Cadel LORD 7 Installer Manual

Hide thumbs Also See for LORD 7:

Table of Contents

PROBLEM

CAUSE

Routine main-

Stove running and

tenance alert (it

display showing

does not block the

"SERVICE"

system)

TECHNICAL DATAS

8.1

Now we give some instructions for the Authorized Technician to take into consideration to have access to stove mechanical com-

ponents.

• For fuse replacement in the electric socket which stands on the back of the stove, extract the fuses to change with the aid of a

screwdriver for opening the shutter (see Fig. 66).

Proceed as follows:

• Remove the sides (see the dedicated chapters).

• After these operations you can have access at the following components: geared motor, ignition plug, ambient fan, fume fan,

ambient probe, fume probe, thermostat, electronic board, pressostat.

• For cleaning or replacemente of the auger it is necessary to unscrew the three bolt of the geared motor and to extract it, un-

screw the two screws lying under the geared motor of the auger, remove the hand rejector inside the hopper and then unscrew

the inner bolt of the auger. (see Fig. 67 Fig. 68).

• To assembly proceed at the contrary.

Fig. 67 - Remove the screws

SOLUTION

When this flashing message appears upon start-up, it means

that the preset operating hours have elapsed before mainte-

nance. Contact the service centre.

Fig. 66 - Shutter with fuses to remove

INTERVENTION

Fig. 68 - Remove the screw

STUFE A PELLET

Table of Contents