Hardware Installation - D-Link SECURICAM Network DCS-900W User Manual

Hardware Installation

Attach the Antenna
Locate the antenna included with your DCS-900W and
attach it to the antenna connector located on the back
of the DCS-900W.
Attach the Swivel Stand
Locate the stand mount on the bottom of the DCS-
900W and screw on the swivel stand.
Connect the Ethernet Cable
Connect the included Ethernet cable to the network
cable connector located on the back panel of the
DCS-900W and attach it to the network.
Attach the External Power Supply
Attach the external power supply to the DC power input
connector located on the rear panel of the
DCS-900W and connect it to your local power supply.
Note: Power source is confirmed when the green LED
Power Indicator located to the right of the lens on the
DCS-900W is illuminated.
Network Connectivity is confirmed when the orange LED Indicator on the DCS-900W
located below the Power LED is illuminated.
9