D-Link SECURICAM Network DCS-900W User Manual page 21

DCS-900W Configuration
Advanced > System
Assign Automatically Using
This options is recommended only for advanced users and network administrators
since it may be difficult to determine the IP Address of the unit after the IP Address
has been automatically asssigned. It is recommended that an IP Address be assigned
manually.
If your network is using RARP, BOOTP, or DHCP Server you can Click Assign
Automatically Using and click on RARP, BOOTP or DHCP. Under this setting the
DCS-900W will automatically assign an IP Address from the RARP, BOOTP or DHCP
Server. Each time the DCS-900W starts up, be sure the RARP, BOOTP or DHCP
Server is set up to assign an IP address to your DCS-900W.
If your application requires direct connection from an ADSL modem through the DCS-
900W's RJ-45 LAN port and you also have an ISP PPPoE account, click on PPPoE and
enter the Service Name, User ID and Password into the respective fields.
The DCS-900W will get an IP Address from the ISP each time it starts up.
(continued)
Important
21