Crestron MT-1000C Programming Manual page 20

3.8 Inch RF Remote
16 • 3.8 Inch RF Remote: MT-1000C
3. Use the Browse button to select an image. Four file formats are
supported, BMP, PCX, DIB, and JPG.
4. The six images are each automatically assigned a definition according
to the order in which they are placed: Very Low, Low, Middle,
Enough, Full, and On Cradle.
5. Use the Append, Insert and Remove buttons
above Battery Level, to add, position, and delete the images.
NOTE: Additional properties may be modified, refer to "Modified Properties"
on page 20.
RF Indicator
The RF indicator consists of two images for active and inactive states. All
programmed button presses will generate an RF signal. The RF indicator
changes from the inactive to active state when a programmed button is pressed.
Buttons that are not programmed will not generate RF and will not change the
state of the RF indicator.
NOTE: You must use two pictures. Using less than two will result in an error
when the program is compiled.
1. Select Draw | RF Indicator and draw the object on the page.
2. Right-click the RF Indicator object and select Properties.
Right-click Sub Menu
Crestron MT-1000C
Programming Guide - DOC. 6330A
located just