Renaming The Axi 02 At In Dante Controller - Extron electronics AXI 02 AT User Manual

Renaming the AXI 02 AT in Dante Controller

NOTE: Dante device naming can also be done via DSP Configurator (see
Tools
1. Ensure that the host PC and the AXI are connected to the same network.
2. From the control computer start menu select:
All Programs>Audinate>Dante Controller>Dante Controller.
The Dante Controller - Network View screen opens. All Dante devices on the
network are discovered and listed.
3. From the Device menu, select Device View or press <Ctrl+D> on the keyboard (see
figure 18).
Figure 18.
The Dante Controller - Device View dialog opens. Select the device being
configured from the (Select a Dante Device...) drop-down (see figure 19,
Figure 19.
NOTE: If there are multiple AXI devices connected to the network that have not
been renamed, obtain the Dante device media access code (MAC) address of
the desired device from the white label on the right side of the device (when
viewed from the front) in order to identify it in Dante Controller.
The Device View dialog populates with the selected AXI information.
Figure 20.
4. Click the Device Config tab (see figure 21,
Config page.
In the Rename Device panel, enter the new name of the device in the text field. No
5.
spaces are allowed in the name. Names should be significant identifiers. For example,
enter AXI02-Breakout1 (
6. Click Apply (
on page 10).
Opening Device View
Device View and Select a Dante Device Drop-Down
Populated Device View Dialog Box
).
2
). A confirmation prompt opens.
3
6
on page 19) to open the Device
1
AXI 02 AT • Dante Controller
under
).
1
18