Reset Modes - Extron electronics AXI 02 AT User Manual

Reset Modes

Press the front panel RESET button (see figure 4,
Tweeker to restart the Dante module in the AXI and leave all other settings unaffected (see
Command and Response Table for SIS Commands
reset output attenuation and preset data).
To cause an absolute system reset of the Dante module back to factory default conditions,
press and hold the front panel reset button for 10 seconds until the AT (PoE) port LEDs
flash. Following this reset, the Dante module will proceed to its normal boot sequence. This
reset will:
•
•
•
Set the IP configuration to default settings
Clear all audio channel routing
Set the Dante device name and channel names to default
on page 5) with a stylus or Extron
D
on page 30 for the command to
AXI 02 AT • Installation and Operation 6