Getting Started With The Enterprise Controller; Creating Still Frames From A Vn-Matrix Video Recording - Extron electronics VNR 100 User Manual

Getting Started with the Enterprise Controller

The VNR 100 single channel recorder is controlled by the VNM Enterprise Controller, which
is used to configure and manage all Matrix devices in the system.
VNR 100 devices are used with VN-Matrix encoders and decoders to record and play back
PURE3 streams. VNR 100 devices may be controlled singly or in groups to enable recording
and playback of more than one stream.
System settings are configured as presets that may then be recalled from either the
VNM Enterprise Controller WEB UI or from an external control system connected to the
VNM Enterprise Controller using the HLI command protocol.
1.
2.
3.
1 1
4.

Creating Still Frames from a VN-Matrix Video Recording

The gcode Frame Translator Utility allows existing VN-Matrix video recordings to be
converted to a series of individual still frames (see
Instructions
Use a PC on the same network as the VNM Enterprise Controller to access the
Website for the controller. Enter the IP address for the controller in the address bar. The
controller Login screen opens:
Figure 12. Enterprise Controller Login Screen
Enter the and
Username Password
Click . The Enterprise Controller Device List opens:
Login
Figure 13. Enterprise Controller Device List
Check the box next to the VNR 100 recorder. A series of action buttons appear at the
bottom of the screen:
Figure 14. Enterprise Controller Device List Action Buttons
Use the Enterprise Controller User Guide (at www.extron.com) for complete
information about configuring and using the VNR 100 recorder.
on page 28).
.
gcode Frame Translator Utility
VNR 100 • Configuration and Hardware Setup 14