Front Panel Features - Extron electronics AXI 02 AT User Manual

Front Panel Features

Figure 4.
A
B
C
D
AXI 02 AT
R
CONFIG
D A C B
AXI 02 AT Front Panel Controls
Power LED Indicator — This green LED blinks during boot up and lights steadily
when the AXI 02 AT is fully operational. This LED also blinks amber for 10 seconds
when the device receives a Dante identification signal (see
Dante Device
on page 22).
USB Config Port — Connect a computer to this USB Mini-B port for device
configuration and firmware updates.
AT (PoE) Port — This RJ-45 port is used to connect the AXI 02 AT to a Dante
network. The AT (PoE) port supports digital audio transport (AT), communication with
the Dante network, communication with DSP Configurator for device configuration, and
power over Ethernet (PoE).
ATTENTION:
• Power over Ethernet (PoE) is intended for indoor use only. It is to be
connected only to networks or circuits that are not routed to the outside
plant or building.
• L'alimentation via Ethernet (PoE) est destinée à une utilisation en intérieur
uniquement. Elle doit être connectée seulement à des réseaux ou des
circuits qui ne sont pas routés au réseau ou au bâtiment extérieur.
• If not provided with a power supply, this product is intended to be supplied
by a UL Listed power source marked "Class 2" or "LPS" and rated output 48
or 56 VDC (PoE), minimum 0.35 A.
• Si ce produit n'est pas fourni avec une alimentation, il doit être utilisé avec
une source d'alimentation certifiée UL de classe 2 ou LPS avec une tension
nominale de 48 Vcc ou 56 Vcc (PoE), un de 0,35 A minimum.
Reset Button — Using a stylus or small screwdriver, press and release this button
to reset the unit to different tiers of factory defaults, including Dante settings such as
device name, IP address, channel names, and audio format (see Reset Modes below).
Power LED Indicator
A
USB Config Port
B
AT (PoE) Port
C
Reset Button
D
Identifying a Physical
AXI 02 AT • Installation and Operation 5