Table of Contents
Advertisement
EACIE Evacuation Alert Control and Indicating Equipment
7.2
Access Level 3 Menu Structure
Figure 11 shows the menu options available at access level 3.
Three 'access levels' are available at the panel; general user is access level 1, authorised user is access level 2
and authorised systems engineer is access level 3. This manual focuses on the programming functions available
at access level 3 only.
At access level 3, you can:
View any active faults that are displayed on the touchscreen.
Gain access to a wide range of engineering functions (see section 7.4) and commissioning functions
(see section 7.5).
Display, filter or clear the panel's event log (see section 7.6).
Set the panel's time and date (see section 7.7).
7.3
How to Enter Access Level 3 (AL3)
Entry to AL3 using the panel's touchscreen
With the panel operating under normal conditions (shown below left), press the
touchscreen to show the access level 1 menu options (shown below right).
Using the touchscreen's numeric keypad, enter the four-digit access level 3 code. The default code is
When the code has been entered correctly, the access level 3 menu options are displayed (shown below right).
Note that the panel will automatically exit access level 3 after approx. 20 minutes without a button press.
Entry to AL3 using the panel's keyswitch and touchscreen
With the panel operating under normal conditions, turn the panel's keyswitch anticlockwise to the horizontal
position to display the access level 2 menu options. As detailed above, press the
input the four-digit access level 3 code.
Installation and Programming Manual Approved Document No. DFU5030020 Rev 1 Page 22 of 38
Press the
button and the display shown below left appears.
button on the panel's
4444
.
button and
Advertisement
Table of Contents
