Table of Contents
Advertisement
EACIE Evacuation Alert Control and Indicating Equipment
Inserting the 'slide-in' labels
5.5
A customisable 'slide-in' label system is employed by the EACIE panel for both the Z41/CA module (for use by
an authorised engineer) and the 8 way switch panels (for use by the FRS).
on C-TEC's website
Label templates for customising are available
.
www.c-tec.com
Z41/CA Control/Display Module Label
The slide-in labels for the programmable LEDs depends on how the unit has been
configured. Insert the labels (supplied in the accessory pack) for the Z41/CA, as
shown right.
Important Note:
Before inserting the horizontal 'Fire/Fault/Disablement/Test' label in the Z41/CA module, create a 'slight'
bend (NOT A FOLD!) at the left-hand side of the label (approx. 20mm). Gently push the label through the slot
provided into its housing using the hinge on the module's rack to assist with finding its path, as shown below.
Switch/Indicator Module Label
Dependent on programming, the slide-in label can be customised on a zone-
by-zone or floor-by-floor basis for each toggle switches.
Insert the slide-in labels (supplied in the accessory pack) for the switch
module(s), as shown right.
Note: The maximum thickness of paper for the label is 80gsm or standard
photocopier paper.
Page 13 of 38 Approved Document No. DFU5030020 Rev 1 Installation and Programming Manual
Advertisement
Table of Contents
