Using The Getting Started Page - Cisco RV120W Administration Manual

Introduction

Using the Getting Started Page

STEP 4
STEP 5
Using the Getting Started Page
Cisco RV120W Administration Guide
Click Log In.
The Setup Wizard starts.
Follow the Setup Wizard's on-screen instructions to set up the RV120W.
The Setup Wizard tries to automatically detect and configure your connection. If it
cannot, the Setup Wizard asks you for information about your Internet connection.
If you don not have it, contact your Internet Service Provider (ISP) to obtain this
information.
During the setup process, the Setup Wizard asks you to enter a new password. To
protect your firewall from unauthorized access, create a new password that is
hard to figure out by others. While you are entering the password, the Setup
Wizard provides you with instant feedback regarding the strength of the
password.
After the Setup Wizard is done configuring the RV120W, the Getting Started
page appears. See Using the Getting Started Page, page 13
information.
The Getting Started page displays the most common Cisco RV120W
configuration tasks. Use the links on this page to jump to the relevant configuration
page.
By default, this page appears when you start the Device Manager. However, you
can change this behavior by checking Don't show this on start up at the bottom
of the page.
1
for more
13