Using The Getting Started Page - Cisco RV 120W Administration Manual

Introduction
Getting Started in the Cisco RV 120W Device Manager
STEP 3
Cisco RV 120W Administration Guide
In the Username and Password fields, enter the default user name (which is admin)
and password (which is also admin), in lowercase letters. Then click Log In.

Using the Getting Started Page

The Getting Started page displays some of the most common configuration tasks.
Click these underlined tasks to view the configuration windows. You can access
the following tasks from the Getting Started page:
Initial Settings
• Change Default Administrator Password—See
Accounts, page
• Configure WAN Settings—See
Network, page
• Configure LAN Settings—See
page 36.
• Review Wireless Profile and Set Security Settings—See
Access Points, page
• Add VPN Clients—See
Quick Access
• Upgrade Device Software—See
• Configure Site to Site VPN—See
• Configure Remote Management Access—See
Management, page
Device Status
• System Summary—See
• Wireless Status—See
• VPN Status—See
To get support for your device, click the Support link at the bottom of the page. To
visit the online support forums, click Forums.
To prevent the Getting Started page from showing when the Device Manager is
started, check the Don't show this on start-up box.
127.
Configuring the WAN for an IPv4
30.
Configuring the Local Area Network (LAN),
66.
Configuring IPsec Users, page
Upgrading Firmware, page
Using the VPN Wizard, page
98.
Viewing Device Statistics, page
Viewing the Wireless Status, page
Viewing the IPsec Connection Status, page
Configuring User
Configuring
114.
138.
102.
Configuring Remote
22.
25.
26.
1
19