Cisco RV120W Administration Manual page 45

Configuring Networking
Configuring Routing
Cisco RV120W Administration Guide
- Gateway—Use gateway.
- R—Reinstate route for dynamic routing.
- D—Dynamically installed by daemon or redirect.
- M—Modified from routing daemon or redirect.
- A—Installed by
- C—Cache entry.
- !—Reject route.
• Metric—The distance to the target (usually counted in hops).
• Ref—Number of references to this route.
• Use—Count of lookups for the route. Depending on the use of -F and -C, this
is either route cache misses (-F) or hits (-C).
• Interface—Interface to which packets for this route will be sent.
• Type—Type of routing used (RIP or static).
IPv6 Routing Table
• Destination—Destination host/network IP address for which this route is
added.
• Next Hop—IP address of an adjacent or intermediate host or router through
which traffic must flow before reaching its ultimate destination.
• Flags—For debugging purpose only; possible flags include:
- UP—Route is up.
- Host—Target is a host.
- Gateway—Use gateway.
- R—Reinstate route for dynamic routing.
- D—Dynamically installed by daemon or redirect.
- M—Modified from routing daemon or redirect.
- A—Installed by
- C—Cache entry.
- !—Reject route.
addrconf
.
addrconf
.
2
36