Cisco RV120W Administration Manual page 122

Configuring Quality of Service (QoS)
Configuring WAN QoS Profiles
STEP 3
STEP 4
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
Cisco RV120W Administration Guide
For more information, see
page 113.
When prompted to reset the previous priority or rate limit configuration, click OK.
Click Save.
Configuring Bandwidth Allocation Settings
To configure the WAN QoS bandwidth allocation settings:
Choose QoS > WAN QoS Profiles.
Under Priority Bandwidth Allocation Settings:
If the WAN QoS mode is set to Priority, enter this information:
High Priority
Medium Priority
Low Priority
Each one of these values specifies the percentage of the total bandwidth
(100 Mbps) allocated to these priority levels.
If the WAN QoS mode is set to Rate Limit, enter this information:
Total WAN (Internet)
Bandwidth
Click Save.
Adding WAN QoS Profiles
To add a WAN QoS profile:
Choose QoS > WAN QoS Profiles.
In the WAN QoS Profile Table, click Add.
Configuring Bandwidth Allocation Settings,
Enter a value between 61 (default) and 100.
Enter a value between 31 (default) and 60.
Enter a value between 10 (default) and 30.
Enter the total WAN bandwidth (1–100 Mbps).
6
113