Viewing The Default Vpn Settings; Configuring Advanced Vpn Parameters - Cisco RV120W Administration Manual

Configuring Virtual Private Networks (VPNs) and Security

Configuring Advanced VPN Parameters

STEP 6
STEP 7
STEP 8
STEP 1
STEP 2
Configuring Advanced VPN Parameters
Cisco RV120W Administration Guide
Choose the type of address for the local gateway (the Cisco RV120W):
• IP Address—Enter the IP address of the gateway in the box below.
• FQDN (Fully-Qualified Domain Name)—Enter the domain name in the box
below (for example, http://www.cisco.com).
If you chose gateway in Step 2, enter the IP address and subnet mask of the
remote LAN. The remote gateway to which the Cisco RV120W will connect is
located on that LAN.
The IP address range used on the remote LAN must be different from the IP
NOTE
address range used on the local LAN.
Click Save.

Viewing the Default VPN Settings

To view the default VPN settings:
Choose VPN > IPsec > Basic VPN Setup.
Click View Default Settings. Settings cannot be changed from this page, but can
be configured through the Basic VPN Setup or Advanced VPN Setup menus.
The Advanced VPN Setup page allows you to configure advanced VPN
parameters, such as IKE and other VPN policies. These policies control how the
Cisco RV120W initiates and receives VPN connections with other endpoints.
5
94