To Provision The Elan Subnet; Provisioning The Elan Subnet - Nortel Meridian 1000 Configuration Manual

Configuring the CS 1000 system

Provisioning the ELAN subnet

Introduction
Define and configure the ELAN subnet for the AML link and its associated VSID in
the configuration record. This provides the Ethernet connection over which AML
messages are exchanged between the CS 1000 system and CallPilot.

To provision the ELAN subnet

1 Load overlay 17.
2 For each prompt listed below, enter the response indicated. For those prompts
that are not listed, you can accept the default by pressing Enter.
Prompt Response
REQ CHG
TYPE ADAN
ADAN NEW ELAN xx Configure a new link and assign it a number, where
CTYP ELAN
DES x...x
REQ CHG
TYPE VAS
VAS new
VSID yy
ELAN xx
68
Description
Change
Action device and number
xx is within the ELAN subnet range (16–31). You can
use any number in this range as long as it is not
already used.
Card type
Enter a designator to identify this ELAN subnet.
Change
Value added server configuration
Configure a new AML link or change the existing link
configuration.
The VAS identifier can be in the range of 16–31. For
convenience, this can be the same number you
assigned to the new ELAN subnet link (in response to
the ADAN prompt).
This should be the same number
defined in ADAN.
Standard 1.16
CallPilot