To Configure The Ip Addresses And Enable The Ethernet Interface; Configuring Cs 1000 Ip Addresses And Enabling The Ethernet Interface - Nortel Meridian 1000 Configuration Manual

January 2007
Configuring CS 1000 IP addresses and enabling
the Ethernet interface
Introduction
If the CS 1000 system has not been defined with the necessary IP address
information (see below), configure the IP addresses for the Ethernet interface. You
must also enable the Ethernet interface, as described in this section.
Notes:
The CS 1000 system has dual CPUs.
If the CS 1000 system is also connected to a Nortel Server Subnet (NS Subnet),
you must define a gateway IP address.
ATTENTION
To configure the IP addresses and enable the Ethernet
interface
The following data is used in examples in this procedure:
Data
Primary IP address
Primary Host Name
Subnet mask
Default gateway IP address
Network IP address
1 Load overlay 117.
2 Perform the following substeps to check the current IP addresses to see if they
already match what you plan to configure for CallPilot.
Communication Server 1000 Meridian and CallPilot Server Configuration
To change an IP address after CallPilot is installed and
running, you must do the following:
1 Courtesy stop and shut down CallPilot.
2 Change the IP addresses on the switch, as described in this
section.
3 Restart CallPilot.
4 Rerun the CallPilot Configuration Wizard to update the switch
IP address information.
Value (examples only)
47.1.1.10
PRIMARY_HOST
255.255.255.0
47.1.1.1
0.0.0.0
Configuring the CS 1000 system
71