To Install The Ds30X Cable For The Mpb96 Board - Nortel Meridian 1000 Configuration Manual

Connecting the CallPilot server to the CS 1000 system
High-capacity—three MPB96 boards and six MGate cards
Three MPB96 boards, installed with six MGate cards, provide a capacity of up to
192 channels and 288 MPUs.
Figure 18: High capacity 3-MPB96 and 6-MGate
CTBus cable
MPB96 #2
MPB96 #3
Note that
all three MGate cards associated with any one MPB96 card should all be
on the same physical shelf backplane. Nortel recommends that M1 traffic
engineering and configuration rules be re-checked whenever adding or moving
MGate cards. (Refer to NTP 553-3021-120.) This may be helpful to ensure that
channel blocking to MGate cards does not occur due to inappropriate M1 superloop
provisioning, M1 backplane partitioning or incorrect M1 backplane cabling.

To install the DS30X cable for the MPB96 board

1 On the bottom of the Media Gateway or Media Gateway Expansion, locate the
connector associated with the slot occupied by the MGate card.
2 Attach the DS30X connector on the NTRH2014 cable to the slot connector as
shown in the previous diagram.
a. Loosen the connector's Velcro fastening strap.
b. Connect the amphenol connector on the MGate cable to the connector on
the back of the Media Gateway or Media Gateway Expansion.
c. Secure the connection by tightening the connector's retaining screw and
Velcro fastening strap.
Figure 19 on page 61 shows how to secure the MGate cable connection.
60
MPB96 #1 DB-44 DS30X-1
DB-44
NTRH2014
MGate #1
MGate #2
MGate #3
MGate #4
DS30X-2
DS30X-3
DS30X-4
DS30X-5
Standard 1.16
Each MGate card
adds up to 32 more
channels if required.
MGate #5
MGate #6
DS30X-6
1002rp_196_4mpb96_3
CallPilot