To Connect The Ds30X Cable - Nortel Meridian 1000 Configuration Manual

Connecting the CallPilot server to the CS 1000 system
Two MPB16-4 boards and two MGate cards (48 channels or less)
Use the NTRH2013 cable, as shown below. Ensure that
the connector labeled DS30X-1 is connected to MGate #1
the connector labeled DS30X-2 is connected to MGate #2
Figure 14: MGate cabling for the 1002rp server
SCbus
cable
MPB16-4 #2

To connect the DS30X cable

Before you begin, review the supported cabling configurations illustrated in Table 6
on page 53.
1 On the bottom of the Media Gateway or Media Gateway Expansion, locate the
connector associated with the slot occupied by the MGate card.
2 Attach the DS30X connector on the NTRH2012 or NTRH2013 cable to the slot
connector as shown in the previous diagrams.
a. Loosen the connector's Velcro fastening strap.
b. Connect the amphenol connector on the MGate cable to the connector on
the back of the Media Gateway or Media Gateway Expansion.
c. Secure the connection by tightening the connector's retaining screw and
Velcro fastening strap.
The following diagram describes how to secure the MGate cable connection.
56
MPB16-4 #1 DB-25
NTRH2013
MGate #1
MGate #2
DS30X-1
DS30X-2
Standard 1.16
G101722
CallPilot