Table of Contents
Advertisement
CHAPTER 12
If the transmission does not start normally, check the following items and perform the troubleshooting.
• The CC-Link cable is properly connected.
• The terminating resistor of CC-Link is properly connected.
• A unique station number has been set for each station on CC-Link.
• AnyWire Bitty devices are being supplied with 24VDC power.
• The LINK LED on the slave module of AnyWire Bitty is flashing.
• The address settings of AnyWire Bitty are correct and unique.
Remark
The reference pages for each specification required during troubleshooting are listed below.
• Connections: Page 27, CHAPTER 4
• Operation mode: Page 32, CHAPTER 5
• Data I/O: Page 35, CHAPTER 6, Page 40, CHAPTER 7
• Details of the LED display: Page 45, CHAPTER 8
For details on the entire AnyWire Bitty system, refer to the "AnyWire Bitty Series Technical Manual" (manufactured by
AnyWire Corporation).
TROUBLESHOOTING
CHAPTER 12 TROUBLESHOOTING
12
55
Advertisement
Table of Contents
Troubleshooting
