Bridge Module To Slave Module (Output) - Mitsubishi Electric CC-Link-AnyWire Bitty Bridge User Manual

11.2.2

Bridge module to slave module (output)

The figure below shows the time between the bridge module remote device (RY) turning on/off and the slave module
output turning on/off.
Slave module
NZ2AW1C1BY
Calculation formula
 Processing time on the bridge module side +  Transmission cycle time  2 +  Signal delay time of the slave
module [ms]
Calculation example
 Processing time on the bridge module side
Processing time of the NZ2AW1C1BY is 0.592ms. : 0.592[ms]
 Transmission cycle time  2
Number of transmission points is set to 512 points: 10.2  2 = 20.4 [ms]
 Signal delay time of the slave module
Signal delay time of the slave module is 0.01ms. : 0.01[ms]
Therefore, the transmission delay time is 0.592 + 20.4 + 0.01  21 [ms].
54
Ô Signal delay time of the slave module
Ó 1- to 2-transmission cycle time
Ò Processing time on the
bridge module side
Input from
the CC-Link side
Output