Transmission Delay Time; Slave Module (Input) To Bridge Module - Mitsubishi Electric CC-Link-AnyWire Bitty Bridge User Manual

11.2

Transmission Delay Time

This section describes the transmission delay time (time until data is transmitted).
11.2.1

Slave module (input) to bridge module

The figure below shows the time between a signal input to the slave module and the bridge module remote device
(RX) turning on/off.
Slave module
NZ2AW1C1BY
Calculation formula
 Signal delay time of the slave module +  Transmission cycle time  2 +  Processing time on the bridge module
side [ms]
Calculation example
 Signal delay time of the slave module
Signal delay time of the slave module is 0.17ms. : 0.17 [ms]
 Transmission cycle time  2
Number of transmission points is set to 512 points: 10.2  2 = 20.4 [ms]
 Processing time on the bridge module side
Processing time of the NZ2AW1C1BY is 0.592ms. : 0.592 [ms]
Therefore, the transmission delay time is 0.17 + 20.4 + 0.592  21 [ms].
Input
Ò Signal delay time of the slave module
Ó 1- to 2-transmission cycle time
CHAPTER 11 TRANSMISSION TIME
Ô Processing time on the bridge
module side
Output to
the CC-Link side
11
53