Error Reset - Mitsubishi Electric CC-Link-AnyWire Bitty Bridge User Manual

6.4

Error Reset

Remote station READY is turned on after the reset by supplying the power.
Error status flag is set (turns on) when an error occurs. Error status flag is reset (turns off) by turning on Error reset
request flag from off, provided that the error cause has been eliminated.
Remote station READY is reset (turns off) when an error has occurred. Remote station READY remains reset (remains
off) until Error reset request flag is turned off.
Error status flag
Error reset request flag
Remote station READY
The remote device values for Remote station READY, Error status flag, and Error reset request flag at each occupied
station setting are shown in the table below.
Name
1 station occupied
Remote station READY
Error status flag
Error reset request flag
An error occurred
Number of occupied stations
2 stations occupied
RX(n+1)A RX(n+3)A
RX(n+1)B RX(n+3)B
RY(n+1)A RY(n+3)A
n: Address assigned to the master station in the station number setting
ON
ON
The flag is turned on
using the user's program
after the error cause is
removed.
3 stations occupied
RX(n+5)A
RX(n+5)B
RY(n+5)A
CHAPTER 6 MEMORY MAPS
OFF
OFF
ON
OFF
4 stations occupied
RX(n+7)A
RX(n+7)B
RY(n+7)A
39
6