Forming; Safety Notes And Protective Measures; Replacing Damaged Or Missing Screws; Cleaning - Siemens MULTIMOBIL 10 Troubleshooting Manual

Service Manual
Service Instructions

1.13 Forming :

If the unit is being installed after six months from the date of despatch, the
capacitors C1~C12 on D970A/D971 need forming. Refer Installation
instructions for forming procedure.

1.14 Safety notes and protective measures

Refer to the General safety note in Chapter on Installation.
Before working on the open MULTIMOBIL 10, switch off the unit with the power
switch at the control panel, the MCB in off position and remove the Mains cable
from socket.
Before inserting or removing PC boards, switch off the generator and observe the
ESD regulations.

1.15 Replacing damaged or missing screws

Damaged or missing screws should only be replaced by steel screws having the
specified tensile strength with Nickel Plating (6492) specified in the Surface Finish
Documents.

1.16 Cleaning

The unit must always be switched OFF or disconnected before cleaning.
Use only water or a Luke warm mixture of a household cleaner diluted with water to
clean the unit.
Do not use an abrasive or organic solvents or cleaning agents containing solvents
such as gasoline used for cleaning purposes, alcohol or stain remover. Do not spray
water on the unit.
1.17 Cleaning the Unit
Switch OFF the system prior to cleaning, disinfecting or sterilizing.
Clean the stand with a damp cloth or cotton pad.
Dampen the cloth or pad with water or lukewarm, diluted commercially available
liquid cleaning solution.
Note:
Do not use scouring powder; organic solvents (may damage materials) or
solvent based cleaning fluids (benzene, alcohol, spot remove).
Siemens Ltd. Med Division India Version 4.0 Page 8 of 48