Setting The Printer Ip Address - Canon N2000 Network Manual

Setting the Printer IP Address

Before setting the printer protocol, you must set the IP address to enable
communication between the printer and the computer. You can use one of the
methods below to set the IP address. Use whichever method is easiest:
•
•
•
Important
NetSpot must be installed on the computer before you can use NetSpot to set the IP
address. The system administrator should install NetSpot on the computer. (
Setup Guide)
If you are using an operating system that is not compatible with NetSpot, you can
use another computer on the network, the ARP/PING command, or the printer
operation panel to perform the IP address setting.
The following procedure is required for the MAC address. To confirm the MAC
address, execute "Ext. I/F Print" with the printer operation panel:
Before setting the IP address, confirm that the printer is switched on and connected
to the network.
If you are using a DHCP, BOOTP, or RARP server where the IP address is
acquired automatically, use the printer operation panel to select "Automatic" for
the "IP Mode" setting, then select ON for the server in use.
If you are using a DHCP, BOOTP, or RARP server, selecting the IP address for the
printer is not required. However, the IP address changes every time the printer is
powered on, so in order to access the printer every time the printer is switched on,
the IP address must be checked.
NetSpot (Canon software application provided with the printer)
ARP/PING command
Printer operation panel
1. Press the Online button. The Online lamp switches off.
2. Press the Cancel Job/Utility button.
3. Press or to select Ext. I/F Print then press .
Setting the Printer IP Address
2-3