Canon N2000 Network Manual page 24

7
Note
8
Important
9
10
2-8
TCP/IP Network Settings (Windows)
If "Automatic" was selected at Step 6, press
"Protocol", press , then select ON or OFF for DHCP, BOOTP, and
RARP.
If "Manual" was selected at Step 6, press
Setting", press , then select "IP Address", "Subnet Mask", or
"Default G/W".
Use the following method to select "IP Address", "Subnet Mask", or "Default G/
W":
1. Press or to select the target field then press
2. Press or to select the desired number then press
3. Repeat Step 1 and 2 for all fields.
Press three times, press
press .
In order to save the settings done in Step 4 to Step 7, you must execute "Regis.
Settings". The selected settings will not be enabled unless they are registered with
"Regis. Settings".
When you see "Execute?" in the operation panel display, press
When you see "Registered!" in the operation panel display, press the
Online button. The Online lamp lights.
The printer is ready to print.
or
or to select "IP
.
.
or to select Regis. Settings, then
to select
.