Setting The Printer Ip Address - Canon imagePROGRAF W2200S User Manual

Setting the Printer IP Address

Before setting the printer protocol, you must set the IP address to enable
communication between the printer and the computer. You can use one of the
methods below to set the IP address. Use whichever method is easiest:
•
•
•
Important
z When you use the GARO Device Setup Utility to perform the printer network
settings, the subnet mask and gateway address settings are set to 0.0.0.0, so use the
Remote UI or printer operation panel to make the settings for your network.
z If you are using an operating system that is not compatible with the GARO Device
Setup Utility, use another computer on the network, use the ARP/PING command,
or use the printer operation panel to perform the settings.
z The GARO Device Setup Utility must be installed on your computer in order to
use this utility to make the settings. Ask your system administrator to install the
GARO Device Setup Utility on your computer. (Æ Setup Guide)
z Before setting the IP address, confirm that the printer is switched on and connected
to the network.
z The MAC address is required to perform the setting with the GARO Device Setup
Utility or the ARP/PING command. If you need to confirm the MAC address, use
the printer operation panel to print a Status Print or Ext. I/F Print.
z Before setting the IP address, confirm that the printer is switched on and connected
to the network.
z If you are using a DHCP, BOOTP, or RARP server where the IP address is
acquired automatically, use the printer operation panel to select "Automatic" for
the "IP Mode" setting, then select ON for the server in use.
z If you are using a DHCP, BOOTP, or RARP server, selecting the IP address for the
printer is not required. However, the IP address changes every time the printer is
powered on, so in order to access the printer every time the printer is switched on,
the IP address must be checked by Status Print or Ext. I/F Print.
GARO Device Setup Utility (Æ P.2-4)
ARP/PING command (Æ P.2-6)
Printer operation panel (Æ P.2-7)
1. Press the Online button. The Online lamp switches off.
2. Press the Cancel Job/Utility button.
3. Press or to select Status Print or Ext. I/F Print then press .
Setting the Printer IP Address
2-3