How To Set Preferences; Accessing Preference Settings - Calculated Industries 4065 User Manual

How to Set Preferences

The following sections detail Preference Setting options for the
Construction Master Pro calculators.
Enter the Preference Mode by pressing Ç ß (Prefs) . Access
each category by pressing the ß key until you reach the desired
setting. Within each category, press the + or – keys to toggle
between individual selections. Press o to exit and set your
Preference.
Note: Press + to advance and press – to back up. Pressing the ß key continuously
in this mode will cycle through all of the Preference Settings.
You may change these settings at any time by repeating the above,
and setting in a new preference.
To reset preferences back to factory default settings, turn your calcu-
lator off, hold down the x key and turn the calculator back on.
For example, if you wish to display all your dimensional area answers
in square meters, press Ç ß ß (Area Std) , then the + key
until "AREA 0.
o or any key, except + or ß, and all your future area answers
will be displayed in square meters.

Accessing Preference Settings

KEYSTROKE
To Set "Fractional Resolution":
Ç ß (Prefs) (1st press of ß )
+ (plus sign)
+
+
+
+
+ (repeats options)
To Set "Area" Answer Format:
ß (2nd press of ß )
+ (plus sign)
+
+
+ (repeats options)
86 — C
ONSTRUCTION
" is displayed. Simply exit this mode by pressing
SQ M
M ® P
ASTER
/ T / D
RO RIG ESKTOP
DISPLAY
FRAC 0-1/16
INCH
FRAC 0-1/32
INCH
FRAC 0-1/64
INCH
FRAC 0-1/2
INCH
FRAC 0-1/4
INCH
FRAC 0-1/8
INCH
FRAC 0-1/16
INCH
AREA Std.
AREA 0.
SQ FEET
AREA 0.
SQ YD
AREA 0.
SQ M
AREA Std.
(Cont'd)