Entering Dimensions; Entering Linear Dimensions; Entering Square/Cubic Dimensions - Calculated Industries 4065 User Manual

ENTERING DIMENSIONS

Entering Linear Dimensions

When entering Feet-Inch-Fraction values, enter dimensions from
largest to smallest — e.g., Feet before Inches, and Inches before
Fractions. Enter Fractions by entering the numerator (top), pressing
/ (fraction bar key), and then the denominator (bottom).
Note: If a denominator is not entered, the fractional setting value is used.
Examples of Entering Linear Dimensions:
DIMENSION
Clear calculator
5 Feet 1-1/2 Inch
Clear calculator
5 Yards
Clear calculator
17.5 Meters

Entering Square/Cubic Dimensions

The Construction Master Pro lets you easily enter Square and Cubic
values. Simply press a dimensional unit key two times to label a
number as a Square value, or three times to label a Cubic value.
Note: If you pass the desired dimensional format, keep on pressing the dimensional
unit key until the desired result is displayed again.
Enter Square and Cubic dimensions in the following order:
(1) Enter numerical value (e.g., 1 0 0).
(2) Press desired unit key (e.g., f) to label value as "linear".
KEYSTROKE
o o
1 0 0 f
(3) Second press of unit key (e.g., f f) labels value as "Square".
KEYSTROKE
o o
1 0 0 f f
(4) Third press of unit key (e.g., f f f) labels value as "Cubic".
KEYSTROKE
o o
1 0 0 f f f
Note: Feet-Inches format cannot be used to enter Square or Cubic values.
18 — C
ONSTRUCTION
M ® P / T
ASTER RO
5 f 1 i 1 / 2
/ D
RIG ESKTOP
KEYSTROKES
o
o
5 y
o
1 7 • 5 m
DISPLAY
0.
100
FEET
DISPLAY
0.
100
SQ FEET
DISPLAY
0.
100
CU FEET